The Nissan Path

jman9895

holy crap! I know this is an older thread but I have never seen that in 10+ years in the industry.. that is wild

jman9895

I'm not sure off the top of my head. I also have fabric not leather :( Generally you use a reamer to grind out those rivets/plastic welds, and then use a hot knife and some of the plastic bits you ground off to melt the welds back together. If you post a pic of the back of the door panel I'll point ...

jman9895

I'm just kinda tossing ideas out here. But if that year was throttle by wire (not sure when they introduced that) and the cluster is dead.. they could be sharing the same source for a refrence signal/power.. When you say the cluster goes dead, do you loose ALL of the cluster? (volts, odometer, fuel ...

jman9895

tirehawk will do that. However, you need to use THEIR sensors and control unit, They have two types of sensors, valve stem and valve cap. I'd be willing to try the valve stem type, as they are inside the tire, however, that would mean replacing the existing sensors and then the OEM tpms system would...

jman9895

where is the whine coming from? it sounds like you may just have a piece of trim that is squeaking. If you can find out where its coming from, you can use soft-side velcro to insulate the parts from each other and keep them from squeaking

jman9895

it would be cool though

jman9895

it is annoying, but I'm more than willing to put up with it though after hearing im not staring down the barrel of a trans rebuild

anyone know what causes it?

jman9895

Ever since I bought my 2012, it shudders at stoplights. I'll be in drive, sitting there, foot on the brake, the whole truck will shake for about 15 seconds, then be normal, if its an exceptionally long light, it will happen a second time... Is this normal for the truck or am I staring down the barre...

jman9895

V6 http://www.batteriesplus.com/products/560-SLI/4807-Car-and-Truck-Batteries/651840-Nissan/Pathfinder/2010-to-2012-V6-4-dot0L-550CCA/1.aspx V8 motors http://www.batteriesplus.com/products/560-SLI/4807-Car-and-Truck-Batteries/651841-Nissan/Pathfinder/2010-V8-5-dot6L-575CCA/1.aspx http://www.batterie...

jman9895

on the pass side, there is actually a module on the underside of the seat, thats what the two other (non yellow) harnesses go into. Not sure what it is. Next time I have the seat out I'll check.

jman9895

I'll look at mine when I get home tonight. Anything with a yellow connector is airbag, Do the wires go anywhere or are they just coming out of the seat to the plate? or from the floor to the plate? It could be they're pre-wired for heat/pwr lumbar Now that I think about it, when I had the pass seat ...

jman9895

I have one using torque as well, its less than 15 bucks on amazon. Thing works great. You cant get much live data, but for pulling codes its great.

jman9895

Nice truck, and welcome to forum! Jealous of the diesel

jman9895

the ones I got for my '12 used the same hardware that held the knockout panels in. came with a harness and a factory-lookalike plug that fit in one of the cutouts on the dash, things cost like 70 bucks on fleabay

jman9895

Oh no question 50 bucks is a shitload of money for a usb charger, just thought it was cool they make one that fits right in one of the factory knockouts.

Search found 89 matches

Shudder while stopped

Nissan Forums

Infiniti Forums

Datsun Forums

Technical Forums

Classifieds / Marketplace

Nissan Motorsports

General Forums