Wish I had been monitoring this sooner. Could have hooked you up with some insider info. I prefer to be in Cambodia during the rainy season like your trip. Fewer local and foreign tourists. Lived in Kampuchea for around a year but I was only able to get up to Siem Reap about three times.
Must be an "07 or '08+ thing, not on my '06 either. I'm pretty sure all of our Pathfinders do this. Nissan has had this feature for decades now. I've done it as far back as '97 on Maxima's. Unfortunately(IMHO) it's an 07+ feature IIRC. Definitely left off of 05 & 06. I would like to have i...
I spent the better part of 2 months living out of my Pathy while traveling for work in addition to several other shorter week or two trips. Window visors for air flow, tint and removing the 2nd row seat bottoms were all requirements in my book. Pulling the seat bottoms instead of flipping them up gi...
IMHO You're going to need to air up and test. That's how I found a good pressure to run mine at. Off the cuff I would say it's not a bad idea to run 40psi as a start/no matter what though. Easier to let a bit of air out than it is to fill up if the sidewalls are flattening out. If your luck would be...
Cleaned up all the grounds in the engine bay, battery connections and transfer motor relay contacts as described. No change. I think the TCU is bad but I still have to check for 4 shorts/open relating to the transfer shut off relay according to the FSM. I ran through the testing procedures yet again...
Easy enough. I'll do that Saturday. I removed and tested the Transfer Shut Off Relay as well as the Transfer Shift High and Low relays yesterday and I planned on cleaning up a few of the grounds in the engine bay and under the dash that relate to these circuits.
Small Update: Was it the switch? Yes but no. The switch is not the root cause. I pulled the switch and before I installed the new one I ohm'd it out and it was perfect. Installed the new, 2nd replacement, switch and nothing, no change. Pulled the switch, disassembled and found the a flat wired burne...
Random update since it's been a while. I have just recently been able to get at this issue. Running through the FSM I believed I narrowed it down to a bad 4WD selector switch as it didn't test out correctly. Swapped it, no change. Fast forward again, completely re-ran through the FSM manual testing ...