Postby smj999smj » Fri Mar 20, 2015 9:15 pm
Most brake controllers will work an any vehicle. I don't know what kind of conversion you have installed. Normally, one would get the Nissan 7-pin conversion kit and install it in the rear, which plugs into the factory harness (so it works through the BCM) and it comes with a 7 flat pin connector and bracket that bolts to the factory hitch. Under the driver's side of the dash, to the left of the steering column, is a plug to be used with the controller. You can get a subharness from Nissan that plugs into it and then you would hard wire it to your controller's harness; some controller manufacturers also make a subharness that is plug-and-play between the controller and the Nissan plug. Of course, then the controller would be mounted. Last, one would need to install a trailer relay into the relay box on the passenger side of the engine compartment. It's a brown relay that Nissan sells for around $28.