To quickly bring everyone up to speed. I have a 2007 2wd Pathfinder and I recently replace upper and lower ball joints. Unfortunately I dropped the driver side hub and steering knuckle. About 60lbs of force and after an Ohm check of the sensor showed open I bought an Autex ABS sensor off of Amazon. The Amazon filter said it was a good fit but I noticed the ohm for this sensor was different than the existing but since it wasn't open I installed it. I started the car after disconnecting the power on the battery and the ABS light was still on.
Does anyone have specs on the Ohms reading that should be seen? Also how many cycles miles should the system take to reset or am I most likely sitting on a bad new part?