can someone help me

[paulstuff71]

I have a 2007 pathfinded v6, its not starting all lights on dash works, battery is good. What i did differently is jacked up the rear put it on stands , ran it in gear for a while due to locating a trans leak, although lights on dash came on (slip,vtc,abs,brake) put the car down to pull it out the garage and now it dosent start..... what happened.......

[eieio]

I have a 2007 pathfinded v6, its not starting all lights on dash works, battery is good. What i did differently is jacked up the rear put it on stands , ran it in gear for a while due to locating a trans leak, although lights on dash came on (slip,vtc,abs,brake) put the car down to pull it out the garage and now it dosent start..... what happened.......

uh-oh, now you've done it!

[paulstuff71]

What have i done

[eieio]

hopefully you haven't confused a computer
be absolutely sure that the battery is in a full state of charge, cables & terminals clean & tight
welcome to the forum
sorry your first post is for a problem
we'll help you as we can

[paulstuff71]

What if tje computer is confused, how do you unconfuse it.

[eieio]

What if tje computer is confused, how do you unconfuse it.

is the starter motor spinning the engine when you try to start it?

[paulstuff71]

No, if the lights and the bell wasnt going on i would think it didnt have a battery.

[eieio]

IMO, you need to eliminate some potential issues before going in to brain surgery on this.
Hopefully, in the long run, brain surgery won't be necessary.
The non-starting symptom(s) may be caused by many things, some simple & basic, some not.
I'm going to lean towards the simpler.........
Here's what I'd do:
charge & load test battery (replace if necessary)
clean battery terminals
clean cable clamps
be sure the clamps tighten down on the battery posts when you tighten the pinch bolts (the negative clamps notoriously do not cinch down on the negative post)
if there is anything wrong with either clamp, replace it
if it still will not start, try disconnecting the battery for several hours (or overnight), and try again
this may solve your problem
please let us know, or if anyone can think of a better "path" to take, please chime in
let us know what happens...........

[paulstuff71]

Thanks, ill try to leave the battery disconnected, its new and fully charged , wow im going through the nissan transmission issue as well.

[eieio]

wow im going through the nissan transmission issue as well.

oh no!
are you covered by extended warranty for that?

[paulstuff71]

No, im at 133,000

[eieio]

No, im at 133,000

ouch!

[eieio]

re: the starting problem, have you checked all of the fuses in both fuse boxes?

[RCAPathfinder]

try disconnecting the battery for a minimum of 45 minutes to reset the computer. Hope that helps

[ZeitGeist]

Disconnect both battery cables then tie them together (keeping both away from the battery!) , terminal to terminal for a minimum of 15 minutes. This confuses the PCM Memory causing re-boot to factory specs. Keep in mind this will clear any archived codes stored.