Help code PO113 / IAT sensor

The Gas and Diesel Engines - VQ40De, VK56DE, YD25DDTi, V9X, Transmission, Transfer Case, Oil, Differentials, Axles, Exhaust...

Moderator: volvite

novaman
Posts: 25
Joined: Sun Dec 12, 2010 1:17 pm
Location: OREGON

Help code PO113 / IAT sensor

Postby novaman » Thu Nov 17, 2011 12:51 pm

Hey everyone I took my 08 pathfinder down and ran the diog it says IAT sensor high input probable cause
Open or short circuit condition
Faulty IAT sensor

I did a lift and unplug the battery and a couple things so would that trip it.
It has 60000 miles. Any help would be great thank a lot.


User avatar
disallow
Site Admin
Posts: 2820
Joined: Wed Aug 13, 2008 9:02 am
Location: Winnipeg, Canada

Postby disallow » Fri Nov 18, 2011 7:01 am

You've done the first step which is to identify the code. Step 2 is always reset the SES light and see if it comes back on.

Disconnecting your battery should not cause any codes.

If the same code comes back, I would look at the IAT sensor. Check that its plugged in properly, and that there isn't intermittent contact in the connector. If all looks good, next step is to replace the sensor.

t

novaman
Posts: 25
Joined: Sun Dec 12, 2010 1:17 pm
Location: OREGON

Postby novaman » Fri Nov 18, 2011 10:27 am

Ok great thank you. Stupid question but I have looked everywhere...... Can you tell me where it's located????

novaman
Posts: 25
Joined: Sun Dec 12, 2010 1:17 pm
Location: OREGON

Postby novaman » Mon Nov 21, 2011 1:45 pm

Anyone????? Can anyone tell me where it is???

CPLTECH
Posts: 222
Joined: Wed Sep 08, 2010 9:30 am
Location: SW Ohio

Postby CPLTECH » Mon Nov 21, 2011 5:21 pm

Service manual Section EC [Engine Control] Pages 199-203.
It shows the P0113 error code, testing procedures, and location.
The manual can be viewed in this section of the forum under a “Sticky” at the top. It’s a great resource.


Return to “R51 Engine, Driveline and Powertrain”