Front Bumper Trim, maybe a factory piece??? Help me out....
Moderator: volvite
"How did you go about doing that?"
It turned out to be pretty straight forward. I got a can of spray Krylon Fusion for plastic at the local hardware store. They said it required no prep for a "superbond" to plastic. I was a little nervous about this but after almost three years it is holding rock solid with no chips or flaking at all.
I masked off the area to be painted and popped off a couple of little plastic trim pieces inside there. I then sanded a little bit with some fine grit sanding pads. After that i wiped it clean with isopropyl alcohol, let it dry and then sprayed it with the Krylon. I still have the can and it is about half full or more.
I got the silver "Textured Shimmer". I was also a little concerned about this being textured as it might hold bug guts or whatever in it but this has not been an issue either.
It turned out to be pretty straight forward. I got a can of spray Krylon Fusion for plastic at the local hardware store. They said it required no prep for a "superbond" to plastic. I was a little nervous about this but after almost three years it is holding rock solid with no chips or flaking at all.
I masked off the area to be painted and popped off a couple of little plastic trim pieces inside there. I then sanded a little bit with some fine grit sanding pads. After that i wiped it clean with isopropyl alcohol, let it dry and then sprayed it with the Krylon. I still have the can and it is about half full or more.
I got the silver "Textured Shimmer". I was also a little concerned about this being textured as it might hold bug guts or whatever in it but this has not been an issue either.
Find Your Forum!