Moderator: volvite
Thanks, and I agree with your concern. I was hesitant at first when I originally started to do this with the washers. However, it can always be undone if it were a problem.asgard wrote:Nice write up and most looks very nice.
I would be concerned with the washers as spacers. The suspension has not only a vertical load applied but a lateral load when cornering or going over rough terrain.
By using spacers you have created a shoulder and a smaller point load to the bolt location. The full contact of the suspension plate relays all the loads over a larger surface dissipating the applied load in a uniformed way.
You might be better with a full spacer.
Just a thought