Search found 23 matches

Return to Search

by TheHawk!
Sat Dec 15, 2018 10:04 am
Forum: Announcements
Topic: Thank you NissanPath Members, activists and Moderators!
Replies: 11
Views: 10103

Check in

Well I’m a little late to the party but check me in! I just bought one of these last week and it works really well lol
by TheHawk!
Wed Dec 12, 2018 10:16 pm
Forum: Classifieds for Pathfinders and Pathfinder Accessories
Topic: WTB ring gear stopper J-48761
Replies: 1
Views: 4114

Tools

PM SENT!
by TheHawk!
Tue Dec 11, 2018 12:13 am
Forum: Classifieds for Pathfinders and Pathfinder Accessories
Topic: Poss FS: 18x8 Rotiform IND w/ OMF Beadlock Ring $700
Replies: 26
Views: 29904

INTERESTED PM ME
by TheHawk!
Sat Dec 08, 2018 6:25 pm
Forum: R51 Engine, Driveline and Powertrain
Topic: VQ40DE low oil pressure, rear timing cover leak
Replies: 7
Views: 7559

You can’t get this gaskets separate unless you order them under Infiniti G for whatever reason. I always replaced the whole rear cover as it’s 2-$300 iirc. Pull the oil sender and put a mechanical gauge on it and check pressure at idle and 2500 rpm after warming up engine. Report back!
by TheHawk!
Sat Dec 08, 2018 6:02 pm
Forum: General Automotive
Topic: Leveling Kit Question
Replies: 4
Views: 3495

New springs and blisters should make a noticeable difference on how it drives. The bushings in the suspension rot/tear overtime and the slightest amount of play in anything adds up quick and it will be all over the road! The order 50 Pathfinders were notorious for the rear trailing arms the bushings...
by TheHawk!
Tue Dec 04, 2018 11:49 am
Forum: R51 Engine, Driveline and Powertrain
Topic: 2006 Pathfinder Timing Chain Tool - WTB
Replies: 4
Views: 3307

Kent Moore

I have one it’s a Kent more J tool. It’s not necessary by any means I’ve used a pry bar in the flex plate access hole in the lower bell housing to hold the flexplate while someone breaks the crankshaft pulley bolt loose and then do the same thing once you get the timing cover off to break the ...
by TheHawk!
Tue Dec 04, 2018 11:49 am
Forum: R51 Engine, Driveline and Powertrain
Topic: 2006 Pathfinder Timing Chain Tool - WTB
Replies: 4
Views: 3307

Kent Moore

I have one it’s a Kent more J tool. It’s not necessary by any means I’ve used a pry bar in the flex plate access hole in the lower bell housing to hold the flexplate while someone breaks the crankshaft pulley bolt loose and then do the same thing once you get the timing cover off to break the ...
by TheHawk!
Mon Dec 03, 2018 2:22 pm
Forum: Southeast US
Topic: Raleigh NC anyone?
Replies: 5
Views: 14260

LEXINGTON NC HERE! KICKING THE DUST OFF THIS THREAD !!!!! LOL I CAN DO ALL PROGRAMMING AND HAVE ACCESS TO EVERYTHING NISSAN IF ANYONE EVER NEEDS KEYS OR ANYTHING!
by TheHawk!
Sun Dec 02, 2018 11:42 am
Forum: General Automotive
Topic: Battery drain overnite
Replies: 7
Views: 5225

you need to buy a cheap digital volt ohm meter that reads amps and put the meter in line between the negative cable and neg batt terminal, lock doors and let truck sit for 30 MINUTES then take note of how many amp draw you have. SHOULD BE SOMEWHERE AROUND 50 MILLI AMP MAX (more likely 15-20 after al...
by TheHawk!
Sat Dec 01, 2018 9:02 pm
Forum: R51 Engine, Driveline and Powertrain
Topic: u1000 - trying to eliminate causes
Replies: 3
Views: 3446

the U1000 code is almost impossible to diagnose without a very good scan tool. shoot me a PM if you need further help
by TheHawk!
Sat Dec 01, 2018 9:00 pm
Forum: R51 Engine, Driveline and Powertrain
Topic: P0442 - EVAP system failure
Replies: 7
Views: 5156

as SMJ said, Its more than likely the valve (95%) of the time but depending on how much dirt is in the canister it may need a EVAP canister also because once it gets stopped up it will set the same DTC!
by TheHawk!
Sat Dec 01, 2018 8:54 pm
Forum: General Automotive
Topic: Keyfob issue
Replies: 4
Views: 3751

most likely the I key fob itself, if not the BCM. I can help you trouble shoot if you need it just shoot me a PM. when issues like those start its generally the fob.....DONT buy a cheap aftermarket one either! the OEM ones arent that expensive!
by TheHawk!
Sat Dec 01, 2018 8:47 pm
Forum: General Automotive
Topic: Replacement key & key fob?
Replies: 4
Views: 7099

Sorry im a little late to the party but if anyone is interested i have scan tools that i rent for programming. if you can type and are a member here than you can program your own key lol you just have to have the appropriate tool
by TheHawk!
Sat Dec 01, 2018 8:25 pm
Forum: Classifieds for Pathfinders and Pathfinder Accessories
Topic: FS: OPT7 9007 HID Kit
Replies: 3
Views: 5323

I have a set of brand new 100 W HELLA bulbs id trade. Last time i bought some i bought 6 sets as most of my vehicles use this bulb and i really like them lol
by TheHawk!
Sat Dec 01, 2018 8:23 pm
Forum: Classifieds for Pathfinders and Pathfinder Accessories
Topic: Radflo Suspension Kit
Replies: 5
Views: 8881

interested also, shoot me a pm if this guy doesnt snag em^ ive got OME parts that need to go if i do upgrade.....

Go to advanced search