So I need to replace the front right ABS sensor on my 2011 4wd Pathfinder.
I cannot because the terminal on the wiring harness where the ABS sensor plugs into is missing. The wire was damaged and spliced/repaired by the previous owner or whoever.
Nissan does not sell this terminal as a pig tail part or an ABS wiring harness...They want you to buy the entire wiring harness for the engine room, which is nuts!!! The entire wiring harness is like $850 and ALOT of unnecessary work! This should be a quick fix…
I looked on eBay and Craigslist for anyone parting out a 2005-2012 Pathfinder with no luck. Any ideas?
On another note…do I need to just remove the brake caliper and rotor to get to the ABS sensor or do I need to remove the entire wheel hub assembly?
I wish I can post pics to reflect what I am doing my best to describe here, but the interface on this posting page is from like 1990! Which was a good year by the way…lol
Please any tips or suggestions would be greatly appreciated. I want to repair this properly as best as I can and get all 4 wheels spinning. My 4wd is not engaging as a result of this and my ABS, VDC OFF and SLIP light is blowing up my dash…((>_<))