Postby Kael2001 » Sun Mar 20, 2016 6:51 pm
From the service manual.
Bleeding Brake System
CAUTION:
While bleeding, monitor the master cylinder brake fluid level.
1. Turn ignition switch OFF and disconnect battery negative cable.
2. Connect a vinyl tube to the rear right bleed valve.
3. Fully depress brake pedal 4 to 5 times.
4. With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
5. Repeat steps 3 and 4 until no more air comes out.
6. Tighten bleed valve to the specified torque. Refer to BR-24, "Components" (front disc brake), BR-31, "Components" (rear disc brake).
7. Perform steps 2 to 6 at each wheel, with master cylinder reservoir tank filled at least half way, bleed air from the front left, rear left, and front right bleed valve, in that order.
You can get a bleed kit from most car parts shops.