Hi,
I am looking to see if anyone has any experience with having one of these installed in their vehicle. I purchased one from a vendor and the voltage is steady @ 12.6 @ idle and then jumps to 15.1 @ 1100 rpms or above. I just don't want to fry my comp or the amps in my car. The Vendor is saying that there needs to be a load on the system in order to prevent the voltage from jumping up & down on the voltage gauge on the dash.
1. Is that normal?
2. I don't have a load on the system as of yet. System in the process of being put in.
3. I already have the over drive pulley installed.
4. I have no installed the Kenetik khc1800 as of yet.
5. I have already down the big 3 grounds.
The amps nor the system is connected as of yet. I am just asking if anyone has run into this problem as of yet.
Thanks in advance