Page 1 of 1

Cleaned throttle body and replace injector. now, high IDLE

Posted: Tue May 18, 2010 6:36 pm
by elcid
Hi guys.

I cleaned the throttle body and replaced an injector. Now, I have a high idle. I am not sure how to bring it down.

I tried lowering it from the IDLE screw, but it refuses to go lower than the 1000rpm it currently runs at when fully warmed.

I am just wondering if I am missing something or there is a speciifc way to lower the idle.

On a additional note, car takes several cranks now to just start up from cold or hot.

Posted: Wed May 19, 2010 1:40 pm
by winter_sled
disconnect the battery to reset the computer and see if that solves it

idle

Posted: Sat May 22, 2010 10:57 pm
by Scaramoche
Yup reset ecu, if that doesnt work, verify timing(after i rebuilt my enginer, i had the same issue, and notice my timing was off, set correctly i now idle at 800 or so rpm