Yes the parts truck turns over no start has the warning lights..palmerwmd wrote:Welcome to ThePath your new home away from home!
I am reading your post.. but can you please clarify what your question is?
Are you asking if it it possible or how hard to transfer parts over?
The warning lights are on your parts truck yes?
So are you trying to address them anyway?
Or are u uncertain which truck you will build up?
Otherwise i see little reason to chase down electric gremlins in the parts vehicle..
My 08 has a little rot on the Passenger Quarter panelunderworld1001 wrote:"Needs bumper covers front and rear
Quarter Panel (Lip above wheel is rotten)
and a Fender; All easy to replace."
Does the parts vehicle have the above in good condition? If not, then occasionally on eBay you can buy pre-painted parts for pretty cheap. I've had my eye on a pre-painted front bumper cover and have seen it as low as $189 shipped and painted. Seller had over a 95% rating so not too bad. Just didn't have the cash at the time.
Not sure about the rear bumper cover to be honest. Haven't priced those out, but I imagine it would be similar.
I saw you were going to cut/weld or piece in the fender piece. If you need to replace the fender, I would keep in mind that the 2005-2007 and 2008-2012 hood and fenders are different if you buy them new. They're slightly longer on the later years to accommodate for the V8 that was offered. At least I know the hood is.
Thanks !!smj999smj wrote:When there is an ECM failure, it can go into a fail safe made and it will have the IPDM turn the radiator cooling fans on. If you question is if you can swap the ECM from one to the other, it should, but you will need to have a Nissan or Infiniti dealer reprogram the ECM software for you vehicle and get it to communicate with the other control units. Or, you could take the bad ECM and set it out to a place like Circuit Board Medics and have it repaired, which "may" save you the hassle from taking it to the dealer.